3 - 8 Document #98210104
Connect the Air Supply
Step 1
Connect your shop air to the dyno.
! Mount the Air Pressure Regulator on the wall
in the shop with the bracket provided.
! Connect a supply air hose to the inlet of the
regulator from your shop air supply.
Note:
Make sure the arrow on the regulator is
the same as the direction of the air flow!
! Connect a
3
/
8
" air hose to the outlet side of the
regulator. Connect the other end of the air hose
to the barbed inlet fitting on the Air Control
Switch (Standard Air) or the Booster Valve
Assembly (Proportional Air) on top of the right
air canister on the dyno.
Note:
The regulator should be set to 60 psi.
Step 2
Connect the air hose (pg. 3-22, letter F) from the
224-4WD Dyno to full line pressure (100-125 psi).
Note:
Be sure that your air source supplies
clean, dry air !
Proportional Air
Hose Hook Up
Standard Air
Hose Hook Up
