A SERVICE OF

logo

Document #98210104 3 - 13
Step 5
Adjust the width of the C-channel assembly until
it is as wide as the pit. Secure the left and right
sides of the C-channel with the cement anchors.
When the sides are anchored, tighten down the
center bolts.
Step 6
Move the dyno through its full range of motion.
Be sure that the dyno is free to move and there are
no obstructions. When you press the “in” or
“out” button on the pendant you should hear the
air release to unlock the rail clamps. After a few
seconds the dyno should begin to move.