Step 6
Install the cement anchors and 1
1
/
2
” bolts. The
bolts should secure the track and track tie. When
the bolts are tightened down, check the square of
the track again. See Figure 3 in Appendix A.
Step 7
Place two straps (capable of supporting a
minimum of 4000 lbs or 1820 KG ) around the
drums. Position the straps so that they are on the
knurled surface of the drum away from the brake
surface.
Step 8
Lower the dyno onto the tracks. Be sure that the
wheel flanges are on the inside of the track.
Document #98210104 3 - 3
Note: The motor side of the 224-4WD should
be facing away from the 248 dyno.
See Figure 5, Appendix A.
Note: See page 3-36 for anchor installation.
Note: The Rail Clamps should be positioned
as shown in Figure 4, Appendix A.
