ENWW Changing networking parameters from the control panel 57
CFG IPX/SPX NO
YES
Selects whether to use the IPX/SPX menu and set
the IPX/SPX protocol parameters.
In the IPX/SPX menu, you can specify the frame
type parameter used on your network.
z The default is AUTO, which automatically sets
and limits the frame type to the first one
detected.
z For Ethernet networks, frame type selections
include EN_8023, EN_II, EN_8022, and EN_SNAP.
z For Token Ring networks, frame type selections
include TR_8022 and TR_SNAP.
In the submenu for Token Ring cards, you can also
specify the NetWare Source Routing parameter,
which can be AUTO (default), OFF, SINGLE R,
or ALL RT.
WEB HTTPS
HTTP/HTTPS
For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP
and HTTPS.
z HTTPS: For secure, encrypted communications,
only HTTPS access is accepted. The print
server will appear as a secure site.
z HTTP/HTTPS: Access using either HTTP or
HTTPS is permitted.
SECURITY KEEP
RESET
Specify whether the current security settings on the
print server will be saved or reset to factory defaults.
z KEEP (default): The current security settings are
maintained.
z RESET: Security settings are reset to factory
defaults.
CFG LINK NO
YES
Selects whether you want to manually configure the
HP Jetdirect 10/100Base-TX print server’s network
link speed and communication mode.
The HP Jetdirect settings must match the network.
The default setting is NO, which bypasses the link
configuration menu items.
If you specify YES, you can select one of the
following link configuration menu items:
z AUTO (default): The print server automatically
configures itself to match the link speed and
communication mode of the network. If it fails,
100TX HALF will be set.
z 10T HALF: 10 Mbps, half-duplex operation
z 10T FULL: 10 Mbps, full-duplex operation
z 100TX HALF: 100 Mbps, half-duplex operation
z 100TX FULL: 100 Mbps, full-duplex operation
Message Value or Submenu Description
