Troubleshooting Analysis Guide (TAGs) 3-109
7
Replace the software diskettes in drives A and B.
• Power-on-reset the printer.
Has the problem been resolved?
No: Replace the signal interface board, then turn to TAG 002: Check & Problem Resolution.
Yes: Software diskettes were at fault. Turn to TAG 002: Check & Problem Resolution.
8
Disconnect J/P76 (hard drive cable).
• Insert the emulation diskette into drive A.
• Power-on-reset the printer.
Has the problem been resolved?
No: Replace the signal interface board, then turn to TAG 002: Check & Problem Resolution.
Yes: Reconnect J/P76 and reload the software onto the hard drive; instructions for loading
software onto the printer’s hard drive are outlined in the Guide to Operations. Then turn
to TAG 002: Check & Problem Resolution.
