A SERVICE OF

logo

Open as PDF
next previous
WR3000 4-Port Wireless DSL/Cable Router
®
66
8.2.3 PPTP Encapsulation - Continued
The following table describes the labels on the screen on the preceding page.
LABEL
DESCRIPTION
DESCRIPTION
ISP Parameters for Internet Access
ISP Parameters for Internet Access
ISP Parameters for Internet Access
ISP Parameters for Internet Access
Encapsulation
PPTP supports on-demand, multi-protocol, and virtual private networking over
public networks, such as the Internet. The WR3000 Wireless Router supports only
one PPTP server connection at any given time. To confi gure a PPTP client, you
must confi gure the My Login and Password fi elds for a PPP connection and the
PPTP parameters for a PPTP connection.
User Name
Type the user name given to you by your ISP.
Type the user name given to you by your ISP.
Password
Type the password associated with the user name above.
Retype to Confi rm
Retype to Confi rm
Type your password again here to ensure that what you entered in the
Password
fi eld above was what you intended.
Nailed-up
Connection
Select
Select
Nailed Up Connection
Nailed Up Connection
if you do not want the connection to time out.
if you do not want the connection to time out.
Idle Timeout
Specify the time in seconds that elapses before the WR3000 Wireless
Specify the time in seconds that elapses before the WR3000 Wireless
Router automatically disconnects from the PPTP server.
PPTP Confi guration
PPTP Confi guration
My IP Address
Type the (static) IP address assigned to you by your ISP.
Type the (static) IP address assigned to you by your ISP.
My IP Subnet Mask
My IP Subnet Mask
Type the subnet mask assigned to you by your ISP (if given).
Type the subnet mask assigned to you by your ISP (if given).
Server IP Address
Server IP Address
Type the IP address of the PPTP server.
Type the IP address of the PPTP server.
Connection ID/Name
Connection ID/Name
Type your identifi cation name for the PPTP server.
Type your identifi cation name for the PPTP server.
Apply
Click
Click
Apply
to save your changes back to the WR3000 Wireless Router.
Reset
Click
Click
Reset
to begin confi guring this screen afresh.
to begin confi guring this screen afresh.
8.3 TCP/IP Priority (Metric)
The metric represents the “cost of transmission”. A router determines the best route for
transmission by choosing a path with the lowest “cost”. RIP routing uses hop count as the
measurement of cost, with a minimum of “ 1” for directly connected networks. The number
must be between “ 1” and “ 15”; a number greater than “15” means the link is down. The
smaller the number, the lower the “cost”.
The metric sets the priority for the WR3000 Wireless Router’s routes to the Internet, if any
two of the default routes have the same metric.