A – Command Line Interface
Set Config Command
59022-06 A A-31
Q
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
MSEnable Management server enable. Enables
(True) or disables (False) management
server on this port. The default is True.
NoClose Loop circuit closure prevention. Enables
(True) or disables (False) the loop’s ability
to remain in the open state indefinitely.
True reduces the amount of arbitration on a
loop when there is only one device on the
loop. The default is False.
IOStreamGuard I/O Stream Guard. Enable (Enable) or
disables (Disable) the suppression of
RSCN messages. The default is Disable.
VIEnable Enables (True) or disables (False) VI
preference routing. The default is False.
Enabling VIEnable will disable
MFSEnable.
CheckAlps Enables (True) or disables (False) the
loop’s ability to close more often. Enable
only for TL_Ports that are having problems
with a specific device. The default is False.
Table A-10. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online, offline,
or diagnostics. The default is Online.
BroadcastEnabled Broadcast. Enables (True) or disables
(False) forwarding of broadcast frames.
The default is True.
InbandEnabled Inband management. Enables (True) or
disables (False) the ability to manage the
switch over an ISL. The default is True.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description
