A – Command Line Interface
Set Config Command
A-34 59022-06 A
Q
zoning
Initiates an editing session in which to change switch zoning attributes. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Falling Trigger The event count below which a falling
threshold alarm is logged. The switch will
not generate another falling threshold
alarm for that event until the count
exceeds the rising threshold and
descends again below the falling
threshold.
Sample Window The period of time in seconds in which to
count events.
Table A-12. Set Config Zoning Parameters
Parameter Description
FC-SW-2 AutoSave Available only when the FC-SW-2
Compliant parameter is True, this
parameter enables (True) or disables
(False) the saving of changes to active
zone set in the switch’s permanent
memory. Refer to ”FC-SW-2 Compliant” on
page A-32. The default is True.
Default Enables (All) or disables (None)
communication among the switch’s ports/
devices and the fabric in the absence of an
active zone set. The default is All.
Table A-11. Set Config Threshold Parameters (Continued)
Parameter Description
