A – Command Line Interface
Show Command
A-50 59022-06 A
Q
LIPF7ALPS This LIP is used to reinitialize the loop. An L_Port, identified
by AL_PS, may have noticed a performance degradation and
is trying to restore the loop.
LIPF8ALPS This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
LIPF7F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIPF8F7 A loop initialization primitive frame used to indicate that a loop
failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not re-established,
a link failure is counted. A link reset is performed after a link
failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by this
port. A loss of synchronization is detected by receipt of an
invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
RxLinkResets Number of link reset primitives received from an attached
device.
RxOfflineSeq Number of offline sequences received. An OLS is issued for
link initialization, a Receive & Recognize Not_Operational
(NOS) state, or to enter the offline state.
TotalErrors Total number of errors detected.
TotalLIPsRecvd Number of loop initialization primitive frames received by this
port.
TotalLIPsXmitd Number of loop initialization primitive frames transmitted by
this port.
TotalLinkResets Total number of link reset primitives.
TotalOfflineSeq Total number of Offline Sequences issued by this port.
Table A-15. Show Port Parameters (Continued)
Entry Description
