A – Command Line Interface
Set Config Command
A-40 59022-10 A
0
LCFEnable Link control frame preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True)
or disables (False) preferred routing of frames with
R_CTL = 1100 (Class 2 responses). The default is False.
Enabling LCFEnable will disable MFSEnable.
MFSEnable Multi-Frame Sequence bundling. This parameter
appears only if AutoPerfTuning is False. Prevents (True)
or allows (False) the interleaving of frames in a
sequence. The default is True. Enabling MFSEnable
disables LCFEnable and VIEnable.
VIEnable Virtual Interface (VI) preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True)
or disables (False) VI preference routing. The default is
False. Enabling VIEnable will disable MFSEnable.
MSEnable Management server enable. Enables (True) or disables
(False) management server on this port. The default is
True.
NoClose Loop circuit closure prevention. Enables (True) or
disables (False) the loop’s ability to remain in the open
state indefinitely. True reduces the amount of arbitration
on a loop when there is only one device on the loop. The
default is False.
IOStreamGuard I/O Stream Guard. Enables or disables the suppression
of RSCN messages. IOStreamGuard can have the
following values:
Enable – Suppresses the reception of RSCN
messages from other ports for which
IOStreamGuard is enabled.
Disable – Allows free transmission and reception of
RSCN messages.
Auto – Suppresses the reception of RSCN
messages under the following conditions: 1) The
port is connected to an initiator device with a QLogic
HBA, 2) The DeviceScanEnable parameter is
enabled. Auto is the default.
PDISCPingEnable Enables (True) or disables (False) the transmission of
ping messages from the switch to all devices on a loop
port. The default is True.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description
