A – Command Line Interface
Set Config Command
A-42 59022-10 A
0
PrincipalPriority The priority used in the FC-SW-2 principal
switch selection algorithm. 1 is high, 255 is
low. The default is 254.
ConfigDescription Switch configuration description. The
configuration description can be up to 32
characters excluding #, semicolon (;), and
comma (,). The default is Config Default.
InteropMode Propagates just the active zone set
throughout the fabric (True, compliant) or
the entire zoning database (False,
non-compliant). The default is True.
LegacyAddressFormat Available only when the InteropMode
parameter is False, this parameter
enables (True) or disables (False) the use
of legacy address formatting for
interoperating with non-FC-SW-2
switches. Refer to ”InteropMode” on
page A-42. The default is False.
Table A-10. Set Config Switch Parameters (Continued)
Parameter Description
