DIS Digital Conference System User Manual
46
User Manual SW 6005 CAA ver 6.2 RevA.docx
Interpreter Units 4.7.2
This screen is used to
configure the use of
Interpreter Units and
Interpretation Channels.
Entries
inserted
by the CUI
Interface application when
information about new
units is received from the
CU Central Unit.
The table can be sorted in
accordance to the various
column
header on top.
Note: If an entry
has been
created, it will not be
deleted automatically, if the
unit is not connected to the
CU Central Unit anymore.
Un-
deleted manually
Figure 4.7-E
Type in the Room # to filter the list to shown only units placed in the room selected.
If rooms are linked together for combining system in more room, this field is used for
identifying which room, the unit is located in. The room number is selected by use of a
drop down box, with a list of configured rooms. The available rooms are set in
Setup/Rooms/Room Configuration.
Each unit has a unique serial number encoded into the unit from the factory.
This field is used to enter the booth number, where the interpreter set is placed. Each
booth can max. be assigned 32 interpreter units. The Language Channel assigned to
the booth is assigned at the ‘Booth Ch. Assignment’.
This information field is for informing the channel number (and language assigned to
this channel) which is assigned as the A-channel. This is set automatically.
Each interpreter booth can use multiple desks. This field is used to identify the desk
no.
This field is used for assigning a language channel to the B-language of the interpreter
set.
This field is used to set the mode for the B-channel:
All channels at the interpreter set can be set to a B-channel.
One channel set as ‘B-language’ can be used at the B-language.
The B-language is not in use.
The text ‘Inserted by CU’ with a time stamp is displayed when the unit was created
automatically by the system. The field can be used to store comments of any kind.
