A SERVICE OF

logo

Open as PDF
next previous
DIS Digital Conference System User Manual
47
User Manual SW 6005 CAA ver 6.2 RevA.docx
AB Switch
Set to ‘On’ the interpreter can switch between the A and B-language with the
microphone ‘On’.
Backlight
Set to ‘On’ switches on the backlight in the LCD display in the interpreter set.
Floor toggle
Set to ‘On’ enable the toggle of the Floor button.
Mic on
Red colour indicates that the microphone is ‘On’.
Interlock modes
Complete
lock
When ticked, no interpreter can switch ‘On’ his microphone to an
occupied channel.
No interlock
When ticked any interpreter can switch ‘On’ his microphone to an
occupied channel. The interpreter who was occupying the channels will
be switched ‘Off’.
Inter booth
lock
A can interrupt A
When ticked, an interpreter can switch ‘On’ his
microphone on his A-channel to a channel occupied
by an interpreter using his A-channel.
The interpreter who was occupying the channels
will be switched ‘Off’.
A can interrupt B
When ticked, an interpreter can switch ‘On’ his
microphone on his A-channel to a channel occupied
by an interpreter using his B-channel.
The interpreter who was occupying the channels
will be switched ‘Off’.
A can interrupt
A+B
When ticked, an interpreter can switch ‘On’ his
microphone on his A-channel to an occupied
channel.
The interpreter who was occupying the channels
will be switched ‘Off’.
Conference
Units CS Display
Abbreviation
When ticked the abbreviation of the language will be shown in the
channel selector display in conference units.
Channel
numbers
When ticked the channel number will be shown in the channel selector
display in conference units.
Please note that Channel Selector Units will always show channel
numbers.
[Replace Unit]
Replaces a unit. See procedures in previous section Setup/Equipment/Conference
Units.
[Save settings in
CU]
Pressing this button will save the current state of the system into the flash memory in
the CU 6105/6110.
After making a setting of a system, it is advisable to save the settings in the CU. Please
also refer to the CU User Manual.
Booth Ch.
Assignment
Use this table to set the language to be used in each interpreter booth. Several booth
can have the same language channels.
Language
Channels
Channel in
use (0-31)
Type in the number of channels to be used. Pressing [Update] will
update the Channel/Language window to show the number of channels
in use.
Language
A language can then be assigned to the channels in use.