A SERVICE OF

logo

Open as PDF
next previous
ZQ110
Rev. 1.00
- 89 -
Mobile Printer Command Manual
BS M S PL PH fn2 m d1~dk
[Name]
[Format]
[Range]
[Default]
[Description]
Set Start characters
ASCII
BS
M
S
pL
pH
fn2
m
d1~dk
Hex
08
4D
53
pL
pH
32
m
d1~dk
Decimal
08
77
83
pL
pH
50
m
d1~dk
3 ≤ (pL+pHx256) ≤ 12
m = 49, 50, 51 32 ≤d ≤127, k ≤ 10
Track 1 : “START1 “
Track 2 : “START2 “
Track 3 : “START3 “
▪ m defines the track to set Start characters.
▪ d indicates the characters to be set as Start characters.
▪ k indicates the number of characters to be used as Start characters.
▪ k is defined as (PL + PH x 256) - 2
▪ If Dynamic sentinel character mode is set by fn1 after setting Start
characters, the Start characters are added to the beginning parts of each
track data after reading card data and then the card data is transmitted.
▪ The specified Start characters are saved to non-volatile memory so the
setting value is not changed even though the printer is reset.
BS M S PL PH fn3 m d1~dk
[Name]
[Format]
[Range]
[Default]
[Description]
Set End characters
ASCII
BS
M
S
pL
pH
fn3
m
d1~dk
Hex
08
4D
53
pL
pH
33
m
d1~dk
Decimal
08
77
83
pL
pH
51
m
d1~dk
3 ≤ (pL+pHx256) ≤ 12
m = 49, 50, 51 32 ≤d ≤127, k ≤ 10
Track 1 : “END1”
Track 2 : “END2”
Track 3 : “END3”
▪ m defines the track to set an End character.
▪ d indicates the character to be set as an End character.
▪ k indicates the number of characters to be used as End characters.
▪ k is defined as (PL + PH x 256) - 2
▪ If Dynamic sentinel character mode is set by fn1 after setting End
characters, the End characters are added to the end parts of each track
data after reading card data and then the data is transmitted.
▪ If d is set to Null 1-byte, it allows the setting of no End character.
▪ The specified End characters are saved to non-volatile memory so the
setting value is not changed even though the printer is reset.