ES-2048 User’s Guide
Chapter 33 Configuration Mode Commands 255
Figure 106 no port-access-authenticator Command Example
33.4.4.3 no ssh
Syntax:
no ssh key <rsa1|rsa|dsa>
no ssh known-hosts <host-ip>
no ssh known-hosts <host-ip> [1024|ssh-rsa|ssh-dsa]
where
An example is shown next.
• Disable the secure shell RSA1 encryption key.
• Remove the remote host with IP address 172.165.1.8 from the list of known hosts.
• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
33.5 Queuing Method Commands
You can use the queuing method commands to configure queuing for outgoing traffic on the
switch. You can only select one queuing method for the switch.
sysname(config)# no port-access-authenticator
sysname(config)# no port-access-authenticator 1,3-5 reauthenticate
sysname(config)# no port-access-authenticator 1,6-7
key <rsa1|rsa|dsa>
= Disables the secure shell server encryption key. Your switch
supports SSH versions 1 and 2 using RSA and DSA
authentication.
known-hosts <host-ip>
= Removes a specific remote host from the list of all known
hosts.
known-hosts <host-ip>
[1024|ssh-rsa|ssh-dsa]
= Removes remote known hosts with a specified public key
type (1024-bit RSA1, RSA or DSA).
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
