Chapter 21 Maintenance
EMG1302-R10A User’s Guide
158
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default EMG1302-
R10A IP address (192.168.1.2). See Appendix C on page 193 for details on how to
set up your computer’s IP address.
21.8 Restart Screen
System restart allows you to reboot the EMG1302-R10A without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 98 Maintenance > Restart
Click Restart to have the EMG1302-R10A reboot. This does not affect the EMG1302-R10A's
configuration.
Upload Click Upload to begin the upload process.
Note: Do not turn off the EMG1302-R10A while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the EMG1302-R10A again. The EMG1302-R10A automatically restarts in
this time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset
Pressing the Reset button in this section clears all user-entered configuration
information and returns the EMG1302-R10A to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
EMG1302-R10A. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
Table 66 Maintenance > Backup/Restore (continued)
LABEL DESCRIPTION
