Chapter 7 WAN
EMG1302-R10A User’s Guide
69
7.4.2 Bridge Encapsulation
This screen displays when you select Bridge encapsulation.
Figure 32 Internet Connection: Bridge Encapsulation
The following table describes the labels in this screen.
Passthrough
PPTP Passthrough
L2TP Passthrough
IPSec Passthrough
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
Table 15 Internet Connection: IP over Ethernet Encapsulation (continued)
LABEL DESCRIPTION
Table 16 Internet Connection: Bridge Encapsulation
LABEL DESCRIPTION
ISP Parameters for Internet Access
Encapsulation Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use routing functions, such as DHCP server.
The function is currently available for the IPv4 protocol.
Enable VID
VID (1~4094) Enter a VLAN identifier between 1 to 4094 (the 802.1Q tag specifies only a priority and
is referred to as a priority tag). In bridge mode, VID 1 (the default VLAN ID) is reserved
for a management VLAN.
Ignore WAN Vlan ID
when tag frame
reveive from LAN
site
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
