Chapter 8 Wireless LAN
EMG1302-R10A User’s Guide
77
Click Configuration > Network > Wireless LAN to open the General screen.
Figure 36 Configuration > Network > Wireless LAN > General
The following table describes the general wireless LAN labels in this screen.
Table 20 Configuration > Network > Wireless LAN > General
LABEL DESCRIPTION
Wireless Setup
Wireless LAN Status This is turned on by default.
You can enable or disable the wireless LAN by using the WLAN switch located on the
back panel of the EMG1302-R10A. The current wireless state is reflected in this field.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Green AP Once Green AP is enabled, if there are no client connections to the AP, the device
switches to 1T1R settings.
Channel Selection Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
This option is only available if Auto Channel Selection is disabled.
Auto Channel
Selection
Select this check box for the EMG1302-R10A to automatically choose the channel with
the least interference. Deselect this check box if you wish to manually select the
channel using the Channel Section field.
Operating Channel This displays the channel the EMG1302-R10A is currently using.
