Chapter 7 WAN
EMG1302-R10A User’s Guide
72
Address Mode Click Dynamic IP if your ISP assigs an IP address.
If you have a fixed IP address assigned to you, click Static IP, and type the IP
Address, Username and Password in the following fields.
Username Enter the username as it is assigned for this account.
Password Enter the designated password for the username in the previous field..
Service Name Enter a name to assign this service.
Reconnect Mode Select Auto Reconnect (always-on) to have the Reconnect Mode continuously
connected.
Select Connect-on-Demand to have the Reconnect Mode only active when WAN
service is active.
Select Manually to only allow WAN reconnection if manually initiated by a user.
Maximum Idle
Time
This value specifies the time in seconds that elapses before the router automatically
disconnects from the PPPoE server.
Remote IPv4
Address
Enter the designated IPv4 address to allow tunneling across ISP network.
Remote PREFIX Enter the IPv6 prefix for the PPPoE tunnel.
6RD
Remote IPv4
Address
Enter the designated IPv4 address to allow tunneling across an ISP network.
Remote PREFIX Enter the IPv6 prefix for the 6RD tunnel. This is only available if 6RD Static-type is
designated.
Primary DNS
Address
Enter the primary DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the secondary DNS server address assigned by the ISP.
LAN IPv6 Address Enter the static IPv6 address assigned to this device.
LAN IPv6 Link-Local
Address
The system assigns a local address designed for use on a single link.
Autoconfiguration Enable/Disable the auto IP address configuration setting.
Autoconfiguration
Type
If autoconfiguration is enabled, the following types are available: IP address, stateful,
and stateless.
Router
Advertisement
Lifetime
The device refreshes the preferred and valid time with each advertisement message.
The device is configured with a valid lifetime value for each network prefix, broadcasted
in the advertisement message.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
Table 18 Configuration > Network > WAN > IPv6 (continued)
LABEL DESCRIPTION
