Prestige 201 ISDN Access Router
Hardware Installation & Initial Setup 2-1
Chapter 2
Hardware Installation & Initial Setup
2.1 Front Panel LEDS of P201
The LED indicators on the front panel indicate the operational status of the Prestige 201. The table below the
diagram describes the LED functions:
Figure 2-1 Front Panel of P201
Table 2-1 LED functions
LED
Description
PWR
The PWR (power) LED is on when power is applied to the Prestige.
SYS A steady on SYS (system) LED indicates the Prestige is on and functioning properly
while an off SYS LED indicates the system is not ready or a malfunction. The
system is rebooting when the SYS LED is blinking.
HUB
1, 2, 3, 4
A steady green light indicates a successful 10Mb Ethernet connection. The LED will
blink when data is being sent/received.
ISDN
LNK, B1, B2
The LNK LED is on when the Prestige is connected to an ISDN switch and the line
has been successfully initialized. The B1 (B2) LED remains steady on when data is
being sent/received on the B1 (B2) bearer channel.
This chapter shows you how to make the cable connections to your
Prestige as well as set up your ISDN connection using the SMT.
