3-11
Cisco IE 2000 Switch Software Configuration Guide
OL-25866-01
Chapter 3 Configuring Switch Alarms
Configuration Examples for Switch Alarms
Setting the FCS Error Hysteresis Threshold: Example
This example shows how to set the FCS bit error rate for a port to 10
-10
:
Switch# configure terminal
Switch(config)# interface fastethernet1/1
Switch(config-if) # fcs-threshold 10
Configuring a Dual Power Supply: Examples
This example shows how to configure two power supplies:
Switch# configure terminal
Switch(config)# power-supply dual
These examples show how to display information when two power supplies are not present which results
in a triggered alarm.
Switch# show facility-alarm status
Source Severity Description Relay Time
Switch MAJOR 5 Redundant Pwr missing or failed NONE Mar 01
1993 00:23:52
Switch# show env power
POWER SUPPLY A is DC OK
POWER SUPPLY B is DC FAULTY <--
Switch# show hard led
SWITCH: 1
SYSTEM: GREEN
ALARM : ALT_RED_BLACK <--
Displaying Alarm Settings: Example
Switch# show alarm settings
Alarm relay mode: De-energized
Power Supply
Alarm Enabled
Relay
Notifies Disabled
Syslog Enabled
Temperature-Primary
Alarm Enabled
Thresholds MAX: 95C MIN: -20C
Relay MAJ
Notifies Enabled
Syslog Enabled
Temperature-Secondary
Alarm Disabled
Threshold
Relay
Notifies Disabled
Syslog Disabled
SD-Card
Alarm Disabled
Relay
Notifies Disabled
Syslog Enabled
Input-Alarm 1
