QGE 100 • Software Configuration and Control 35
The QGE 100 Viewer Window
Figure 26. QGE 100 Viewer Main Window
The main window of the QGE 100 Viewer consists of the following major sections:
• Source window — (Left pane) Displays the source connected to the selected
QGE 100. If no source is connected, this section displays Not Connected.
• Channel list — (Right pane) Displays all QGE 100s available on the network. The
following parameters are displayed for each QGE:
Parameter Description
QGE 100 Name of the QGE 100 (if assigned)
IP Address IP address of the QGE
Type This field always displays Hardware.
Protocol Current operating mode (TCP Unicast or UDP Multicast)
Multicast Group (Multicast mode only) The multicast IP address currently set
Port The port number for multicast connection. This is normally
set to 5000, which is the default value expected by the
QGE 100 Viewer and QGE-enabled image processors.
