QGE 100 • Software Configuration and Control 41
Mouse and Keyboard Control of the Source Computer
The keyboard and mouse of the computer that is running QGE 100 Administrator or
QGE 100 Viewer can be set up to control (emulate mouse and keyboard operation of) the
source computer through the QGE 100. This is available only when the QGE is in unicast
mode. (QGEs in multicast mode cannot be set up for remote control because they can
have more than one viewing device connected.)
Enabling Mouse and Keyboard Control
To enable control of the source computer by the keyboard and mouse of your viewing
computer through the QGE:
1. Ensure that the QGE 100 is connected between the source computer and its keyboard
and mouse via the four PS/2 connectors (see “Connecting the Source Computer to
the QGE 100” in the “Installation” section).
2. Ensure that the QGE is in unicast mode (the Multicast Enabled check box must be
cleared; see “Configuring UDP multicast settings” on page 31).
3. From the Tools menu of the Administrator or the Viewer software main window,
select Mouse & Keyboard Options.
4. Configure the mouse and keyboard options as desired (see “Configuring keyboard
and mouse control options,” below).
5. On the QGE 100 Viewer main window or the QGE 100 Administrator Viewer
window, select Mouse & Keyboard from the Tools menu. A check mark appears in
front of this option to indicate that mouse and keyboard control is enabled. You can
now start a control session (see “Starting and stopping a mouse and keyboard
control session” on page 43).
Configuring keyboard and mouse control options
1. From the Tools menu of either software program main window, select Mouse &
Keyboard Options. The Mouse & Keyboard Options window opens:
Figure 30. Mouse & Keyboard Options Window
