Redundancy (Switches 8200zl)
Using Redundant Management
Using Redundant Management
There are new CLI commands for redundant management as well as
modifications to existing commands. (See “Existing CLI Commands Affected
by Redundant Management” on page 15-29)
New Redundant Management Commands
Page
redundancy management-module below
redundancy switchover 15-8
redundancy active-management 15-9
redundancy fabric-module 15-12
show redundancy 15-5;15-27
Displaying Redundancy Status
You can display the status of both the management and fabric redundant
modules using this command:
Syntax: show redundancy
Displays the status of the management and fabric modules.
An example of the output for the show redundancy command is seen in Figure
15-1.
15-5
