Troubleshooting
Locator LED (Locating a Switch)
Locator LED (Locating a Switch)
To locate where a particular switch is physically installed, use the chassislo-
cate command to activate the blue Locator LED on the switch’s front panel.
Syntax: chassislocate [blink | on | off]
Locates a switch by using the blue Locate LED on the front panel.
blink <1-1440>
Blinks the chassis Locate LED for a specified number of minutes
(Default: 30 minutes).
on <1-1440>
Turns the chassis Locate LED on for a specified number of
minutes (Default: 30 minutes).
off
Turns the chassis Locate LED off.
ProCurve(config)# chassislocate
blink <1-1440> Blink the chassis locate led (default 30 minutes).
off Turn the chassis locate led off.
on <1-1440> Turn the chassis locate led on (default 30 minutes).
ProCurve(config)# chassislocate
Figure C-42. Locating a Switch with the chassislocate Command
For redundant management systems, if the active management module fails-
over, the Locator LED does not remain lit.
C-96
