Redundancy (Switches 8200zl)
Logging Messages
Logging Messages
Log File
The log file displays messages about the activities and status of the
management modules. Enter this command to display the messages:
Syntax: show logging
Displays log events.
For more information on command options available with the show logging
command, see “CLI: Displaying the Event Log” in the “Troubleshooting”
chapter of this guide.
An example of the log file listing is shown in Figure 15-31.
ProCurve(config)# show logging
Keys: W=Warning I=Information
M=Major D=Debug
---- Event Log listing: Events Since Boot ----
M 01/26/14 17:34:07 sys: 'System reboot due to Power Failure'
I 01/26/14 17:34:07 00061 system: ---------------------------------------------
I 01/26/14 17:34:07 00062 system: Mgmt Module 2 went down without saving crash
information
I 01/26/14 17:36:14 00264 system: Mgmt Module 1 Failed Selftest
I 01/26/14 17:36:19 00068 chassis: Fabric 1 Inserted
I 01/26/14 17:36:19 00068 chassis: Fabric 2 Inserted
I 01/26/14 17:36:19 00068 chassis: Slot D Inserted
I 01/26/14 17:36:19 00690 udpf: DHCP relay agent feature enabled
I 01/26/14 17:36:19 00400 stack: Stack Protocol disabled
I 01/26/14 17:36:19 00128 tftp: Enable succeeded
I 01/26/14 17:36:19 00417 cdp: CDP enabled
I 01/26/14 17:36:19 00688 lldp: LLDP - enabled
I 01/26/14 17:36:19 00066 system: Mgmt Module 2 Booted
I 01/26/14 17:36:19 00260 system: Mgmt Module 2 Active
I 01/26/14 17:36:19 00066 system: Mgmt Module 1 Booted
I 01/26/14 17:36:19 00261 system: Mgmt Module 1 in Standby Mode
I 01/26/14 17:36:27 00375 chassis: Slot D Downloading
I 01/26/14 17:36:29 00376 chassis: Slot D Download Complete
I 01/26/14 17:36:44 00422 chassis: Slot D Ready
I 01/26/14 17:39:28 00179 mgr: SME CONSOLE Session - MANAGER Mode
I 01/26/14 21:49:10 00261 system: Mgmt Module 1 in Standby Mode
---- Bottom of Log : Events Listed = 21 ----
Figure 15-31. Log File Listing
15-41
