Adjusting Standard Tray Paper Guides
Printer Tasks 3-3
Printer Tasks
4. Install the custom tray as shown in Figure 3-3. Angle the tray down slightly until it
engages the tray guides on either side of the printer, then push the tray in as if it were a
standard tray.
Figure 3-3 Installing Custom Tray
Adjusting Standard Tray Paper Guides
The printer’s standard tray accepts all the standard paper formats listed in and illustrated in
Figure 3-4. A set of moveable paper positioning guides lock into place in the paper trays, with
the paper size visible through a cutout on the guide.
Table 3-1 Paper size settings in Standard Tray
Category Dimensions
Letter 8.5 x 11 in (216 x 279 mm)
Legal 8.5 x 14 in (216 x 356 mm)
Ledger 11 x 17 in (280 x 432 mm)
Executive 7.25 x 10.5 in (184 x 267 mm)
A3 11.69 x 16.53 in (297 x 420 mm)
A4 8.26 x 11.69 in (210 x 297 mm)
A5 5.84 x 8.26 in (149 x 210 mm)
B4 (JIS) 10.11 x 14.32 in (257 x 364 mm)
B5 (JIS) 7.16 x 10.11 in (182 x 257 mm)
* LGR note: Ledger paper extends across the entire tray bottom. When you install ledger paper, lift and
remove the left guide and store it in the molded pocket (located on front panel) labeled LGR.
JIS: Japan Industrial Standards Committee
LTR
LTR
