96 USING THE M208’S COMMAND SET: npsh Command Set
examples for a particular command are provided at the end of that command’s main
section and when another command or other information may be useful, a reference is
given.
cancel
cancel
jobid
Delete a job from the M208’s internal queue.
See also: lpstat on page 103.
chr
chr
arguments
Used with redirection, the chr command sends output control codes to the
printer. Separate arguments with spaces. Arguments can be a combination of
words, any printable character, or the common set of $BS, $TAB, $ESC,
$DEL, $EOF, $NULL, $FF, $LF, or 0xhh (hexadecimal code for any charac-
ter).
chr $LF
causes an extra linefeed before the next prompt.
See also: Redirecting Output from Commands on page 94.
config hub
config hub [
portnum
]
arguments
Configure hub port parameters. The arguments can be the following and if
used with a “-”, the arguments will be reversed:
The config command is functionally similar to a store command followed by
a reset command. The config command stores the setting to EEPROM and
automatically resets the unit. The config command only works with the hub
settings.
[-]enable Enables or disables a particular port. If a port has been dis-
abled, it must be enabled before it will autosense a device
attached to it.
Examp
e
Note
