124 USING THE M208’S COMMAND SET: npsh Command Set
mask
]
Add or delete a host or network in the TCP connection access list. An empty
list allows any host to have TCP sessions with the M208.
store tcpip tcp access add root 192.75.30.11
Provides the host with IP address 192.75.30.11 root access to the M208.
store tcpip tcp opts [-]keepalive
Enable or disable the keepalive packet usage in the TCP stack.
store tcpip tcp rxwin
packetsize
Modify the receive window size property for TCP connections. packetsize is
the number of full size packets and must be in the range 1 to 8. The higher the
number, the less simultaneous TCP connections.
See also: list tcpip on page 101.
supervisor
supervisor
Gives you root permissions when utilizing the Novell host software,
npsh.exe, to start a full session with the M208.
See also: Host Software on page 63 and User Accounts and Permissions on
page 94.
telnet
telnet
ipname
[
escapecharacter
[
portnumber
]]
Telnet from the M208 to another host on the network specified by its ipname.
ipname can be either an IP address or an IP name. By specifying a TCP port-
number, you can also connect to a specific socket on the target host.
If escapecharacter is used, it resets the key sequence to exit you to command
mode indicated by the telnet> prompt. In this mode, you can execute:
quit Exit the Telnet session.
Examp
e
