A SERVICE OF

logo

Open as PDF
next previous
Chapter 5: Installing Additional Memory
41
6. Tighten the two captive screws at the end of the extraction handle.
7. Place the two board clamps along the sides of the memory board such that the screws align
with their respective holes.
8. Secure the two board clamps with the two board clamp screws.
9. Place the bracket with the thumbscrew that locks the extraction lever over the extraction levers
and tighten the screw.
10. Replace the DC-DC converters as described in “Installing the Memory Board DC-to-DC
Converters” in Chapter 5.
11. If you removed any DIMMs replace them as described in “Installing DIMMs” in Chapter 5.
Replace the Processor/Memory Complex as described in “Installing the Processor/Memory
Complex” in Chapter 5.