A SERVICE OF

logo

Open as PDF
next previous
Chapter 5. Replacing Supplies 5–29
Replacing the Fuser Access Door
Use the following procedure to replace the fuser access door on the printer.
1. Make sure that the feeder access door is open.
2. Hold the fuser access door with the top edge pointing down and align the
2 pivots on the door with the 2 brackets on the frame (the door pivot on the
right has a tab that aligns with the cutout [1] in the right bracket). Slide the
door to the right and rotate it up.
3. Grasp the tab at the top of the strap on the fuser access door [1]. Insert the
tab into the cutout in the printer frame [2] and slide the tab down until the
top of the tab [3] aligns with the hole in the frame [4]. Push the tab into the
hole in the frame and lock it in place.