6–26 IBM Network Color Printer Operator’s Guide
Setting the Separation Corona Mode
This section tells you how to set the separation corona mode using the density
control panel.
You may need to set the operational mode of the separation corona to resolve
a particular print quality problem. The separation corona can be on or off or set
to function automatically (sensitive to temperature and humidity).
Use the following procedure to set the separation corona mode.
1. While holding down the COLOR SELECT push button, press the ENTER
push button 3 times. The Y and Bk color select lights flash to indicate that
you can set the mode of the separation corona.
2. Use the (–) or (+) push button to select the separation corona mode. If the
chosen mode differs from that currently selected in the printer, the density
gauge light flashes.
The correspondence between the density gauge lights and each
separation corona mode is as follows:
3. Press the ENTER push button to confirm the separation corona mode. The
density gauge light comes on and the printer changes the separation
corona mode.
