Table 4. Configuration Parameter List - APPN Routing (continued)
Parameter Information
Parameter
Use enhanced INTERSC COS
Valid Values
YesorNo
Default
Yes
Description
This parameter specifies whether to use the enhanced COS tables. The enhanced
tables assign reasonable weights to ATM TGs based on cost, speed, and delay. For
ATM, the order of preference is:
v Campus Reserved (SVC or PVC)
v Campus Best Effort (SVC or PVC)/WAN reserved PVC
v WAN Reserved SVC
v WAN Best Effort (SVC or PVC)
Syntax:
set
high-performance routing
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 5. Configuration Parameter List - High-Performance Routing (HPR)
Parameter Information
Parameter
Maximum sessions for HPR connections
Valid Values
1 to 65535
Default Value
100
Description
This parameter specifies the maximum number of sessions allowed on an HPR
connection. An HPR connection is defined by the class of service (COS), the physical
path (TGs), and the network connection end points.
This parameter is applicable only when the router is the initiator of the BIND. If the
number of sessions exceeds the specified value for this parameter, HPR will allocate
another HPR (RTP) connection.
Table 6. Configuration Parameter List - HPR Timer and Retry Options
Parameter Information
Low transmission priority traffic
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 89
|
|
|
