number of subsequent call requests that are attempted by the
out-static circuit before no further attempts are made. At this point,
a call failure is logged and operator intervention is required to
activate the out-static circuit.
Initial Min Timer
Specifies the amount of time (in seconds) an out-static circuit waits
for a link to be initialized (reception of either an ESH or an ISH)
after the call request has been accepted. If the initial min timer
expires before the link has been fully initialized, the SVC is cleared
and an event generated that indicates initialization failure.
Enable IS-IS
Defines whether the IS-IS protocol is enabled on this routing-circuit.
When set to ON, the IS-IS protocol is enabled; when set to OFF,
the IS-IS protocol is not enabled.
Level2 Only
Specifies if this routing-circuit is used for Level2 routing only.
External Domain
Specifies whether the router transmits and receives messages to
and from a domain outside its IS-IS routing domain.
Default Metric
Defines the cost of this address.
ISIS Hello Timer
Defines the time interval between transmission of ISIS hellos.
Enable DECnetV Link Initialization
Defines whether DEC-style link initialization for this circuit is
enabled (YES) or not (NO).
Modify Receive Verifier
Specifies verification data to be checked against on receiving an
XID when verifying by circuit.
Modify Transmit Verifier
Specifies verification data to be included in the XID.
Explicit Receive Verification
Defines whether verification is by circuit or by system. TRUE
specifies verification by circuit, and FALSE specifies by system.
Reserve Timer
Defines the time after the idle timer expires during which the router
still considers a remote node on a DA circuit as “active.” The router
can forward data on the DA circuit until the reserve timer expires.
Idle Timer
Defines the length of time a DA adjacency my be idle (no data
transmission) before it is cleared.
Max SVCs
Defines the maximum number of SVC adjacencies supported by
this DA circuit. If no call can be placed because the maximum SVC
adjacencies has been reached, then an event "Exceed Max SVC
adjacencies" is generated.
receive-password
Adds an ASCII character string (16 characters maximum) that authenticates
all incoming packets. An incoming packet whose password matches one of
DECnet V/OSI Configuration Commands (Talk 6)
310
MRS V3.2 Protocol Config Ref Vol 2
