add address
net address prefix
leaked-routes
destination
packet-filter
name interface
route
destination mask gateway cost ...
tunnel
destination prefix raddress locaddress cost ttl
fragmentation
Example:
IPV6 config>add address
Which net is this address for [0]? 5
New address []? 1::2
Prefix length must between 8 and 128 [128]?
IPV6 config>add leaked
IPV4 destination []? 1.2.3.4
Address mask [255.0.0.0]? 255.255.255.255
IPV6 config>add packet-filter
Packet-filter name []? pktf01
Which interface is this filter for [0]? 3
IPV6 config>add route
IPV6 destination []? 8::9
Prefix length must between 8 and 128 [8]? 128
Via gateway 1 at []? 1::2
Cost [1]?
Via gateway 2 at []? 2::3
Cost [1]? 1000
Via gateway 3 at []? 3::4
Cost [1]? 10000
Via gateway 4 at []? 4::5
Cost [1]? 10
IPV6 config>add tunnel
Add a static route through this tunnel? [Yes[:
IPV6 destination network []? 3::4
Prefix length must between 0 and 128 [64]? 128
IPV4 tunnel remote address []?1.2.3.4
IPV4 tunnel local address []? 2.3.40.0
Cost [1]?
TTL value [64]?
Allow fragmentation in tunnel?(Yes or [No]):
address
Adds an IPv6 address.
Which net is this address for
Specifies the net to which the IPv6 address is to be added.
Valid Values: A numeric value identifying a network interface
Default Value:0
New address
Specifies the new IPv6 address to be added.
Valid Values: Any valid IPv6 address
Default Value: None
Prefix length
Decimal value specifying how many of the leftmost contiguous bits
of the address comprise the prefix.
Valid Values:8-128
IPV6 Configuration Commands (Talk 6)
384
MRS V3.2 Protocol Config Ref Vol 2
||
||
||
||
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
