5: Commands and Levels
EDS-MD Command Reference 78
device (device) level commands
Continuously displays the internal trouble log.
Exit to the enable level.
show hardware information
Displays information about the hardware.
Displays the last 20 commands entered during the current CLI
session.
Displays current memory usage information.
Displays current task states.
Displays the internal trouble log.
Stores the current configuration in permanent memory.
diagnostics (config-diagnostics) level commands
Returns to the config level.
Enters the next lower level.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Stores the current configuration in permanent memory.
disconnect (tunnel-disconnect:8) level commands
Returns to the tunnel level.
Does not flush serial data upon closing a tunneling connection.
Flushes serial data buffer when a tunneling connection is
closed.
flush stop character disable
Forwards the stop character from the Line to the network.
flush stop character enable
Prevents the stop character from the Line from being for-
warded to the network.
Does not watch the modem control pin to disconnect.
Watches the modem control pin and disconnects if it is not
asserted.
Removes the stop character.
Disables disconnect after timeout feature for tunneling ses-
sions.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Sets the stop character.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Disconnects when no data has been received on the line (serial
port) for the
specified length of time.
<milliseconds> = timeout in milliseconds.
Stores the current configuration in permanent memory.
