A – Command Line Interface
Set Config Command
59097-02 B A-73
A
The following is an example of the Set Config Security command:
SANbox xxxx #> admin start
SANbox xxxx (admin) #> config edit
SANbox xxxx (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
FabricBindingEnabled (True / False) [False]
AutoSave (True / False) [True ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
The following is an example of the Set Config Switch command:
SANbox xxxx #> admin start
SANbox xxxx (admin) #> config edit
SANbox xxxx (admin-config) #> set config switch
A list of attributes with formatting and default values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
AdminState (1=Online, 2=Offline, 3=Diagnostics) [Online ]
BroadcastEnabled (True / False) [True ]
InbandEnabled (True / False) [True ]
FDMIEnabled (True / False) [True ]
FDMIEntries (decimal value, 0-1000) [1000 ]
DefaultDomainID (decimal value, 1-239) [2 ]
DomainIDLock (True / False) [False ]
SymbolicName (string, max=32 chars) [SANbox ]
R_A_TOV (decimal value, 100-100000 msec) [10000 ]
E_D_TOV (decimal value, 10-20000 msec) [2000 ]
PrincipalPriority (decimal value, 1-255) [254 ]
ConfigDescription (string, max=64 chars) [Default Config]
InteropMode (0=Standard, 1=Interop_1) [Standard ]
