B – Command Line Interface
Set Command
B-26 59043-01 A
log [option]
Specifies the type of entries to be entered in the event log. Refer to the ”Set Log
Command” on page B-35.
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to
the value given by [state]. This keyword is available with User authority. [state] can
be one of the following:
on
Limits the display of information to 20 lines at a time. The page break
functions affects the following commands: Alias (List, Members), Show
(Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active,
List).
off
Allows continuous display of information without a break.
port [option]
Sets port state and speed for the specified port temporarily until the next switch
reset or new configuration activation. Refer to the ”Set Port Command” on
page B-38.
setup [option]
Changes SNMP and system configuration settings. Refer to the ”Set Setup
Command” on page B-40.
switch [state]
Temporarily changes the administrative state for all ports on the switch to the state
given by [state]. The previous Set Config Switch settings are restored after a
switch reset or a reactivation of a switch configuration. [state] can be one of the
following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
