A SERVICE OF

logo

6 Removal/Replacement
I/O Blades
59043-01 A 6-9
7. Using a flat-bladed screwdriver, loosen the captive screws at the top and
bottom of the I/O blade faceplate as shown in Figure 6-2. The bottom screw
is under the latch. Grasp the latch and press the red release button, then
rotate the latch downward to disengage the I/O blade from the backplane
connector. Carefully slide the I/O blade out of the slot.
Remove all connections from the IO blade in slot 6.
Remove the IO blade in slot 6 from the chassis.
Please confirm that these steps have been accomplished by
pressing the ENTER key.
Hotswap IO blade removal sub-procedure successfully
completed.
Figure 6-2. Removing an I/O Blade
8. To install a new I/O blade, enter y.
Do you want to continue with the replacement procedure?
(y/n): [n] y
Release Button
Latch
Screw
Screw
Ground Jack