A SERVICE OF

logo

Open as PDF
next previous
6 – Removal/Replacement
CPU Module
6-4 59043-01 A
8. To unfasten the CPU module, disconnect the Ethernet and serial cables
from the CPU module. Connect an ESD wrist strap to a ground point on the
chassis or rack. Using a flat-bladed screwdriver, loosen the four captive
screws at the top and bottom of the CPU module faceplate as shown in
Figure 6-1. The bottom-left screw is under the latch.
Figure 6-1. Removing the CPU Module
9. To remove the CPU module, grasp the latch and rotate it downward to
disengage the CPU module from the backplane connector. Carefully slide
the CPU module out of the slot.
CAUTION!
The CPU module contains sensitive logic components. To avoid
damage to the module, do not touch the CPU module components.
Latch
Screws
Screws