B – Command Line Interface
Show Command
59043-01 A B-47
FReject Number of frames from devices that were
rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
LIP ALPD ALPS Number of F7, AL_PS LIPs, or AL_PD
(vendor specific) resets, performed.
LIPF7ALPS This LIP is used to reinitialize the loop. An
L_port, identified by AL_PS, may have
noticed a performance degradation and is
trying to restore the loop.
LIPF8ALPS This LIP denotes a loop failure detected by
the L_port identified by AL_PS.
LIPF7F7 A loop initialization primitive frame used to
acquire a valid AL_PA.
LIPF8F7 A loop initialization primitive frame used to
indicate that a loop failure has been
detected at the receiver.
Link Failures Number of optical link failures detected by
this port. A link failure is a loss of
synchronization for a period of time
greater than the value of R_T_TOV or by
loss of signal while not in the offline state.
A loss of signal causes the switch to
attempt to re-establish the link. If the link is
not re-established by the time specified by
R_T_TOV, a link failure is counted. A link
reset is performed after a link failure.
Login Time when user logged in.
Logout Time when user logged out.
LoopTimeouts A two (2) second timeout as specified by
FC-AL-2.
LossOfSync Number of synchronization losses (>100
ms) detected by this port. A loss of
synchronization is detected by receipt of
an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
Table B-13. Show Port Parameters (Continued)
Entry Description
