xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
299
show sim
Purpose Used to view the current information regarding the SIM group on the Switch.
Syntax
show sim {[candidates {<candidate_id 1–100>} | members {<member_id 1–32>} |
group {commander_mac <macaddr>}] | neighbor]}
Description This command is used to display the current information regarding the SIM group on the
Switch, including the following:
SIM Version – Displays the current Single IP Management version on the Switch.
Firmware Version – Displays the current Firmware version on the Switch.
Device Name – Displays the user–defined device name on the Switch.
MAC Address – Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the Switch, whether it
be enabled or disabled.
Role State – Displays the current role the Switch is taking, including Commander,
Member or Candidate. A Stand–alone switch will always have the commander role.
Discovery Interval – Time in seconds the Switch will send discovery packets out over
the network.
Hold time – Displays the time in seconds the Switch will hold discovery results before
dropping it or utilizing it.
Parameters candidates <candidate_id 1–100> – Entering this parameter will display information
concerning candidates of the SIM group. To view a specific candidate, include that
candidate’s ID number, listed from 1 to 100.
members <member_id 1–32> – Entering this parameter will display information
concerning members of the SIM group. To view a specific member, include that
member’s ID number, listed from 1 to 32.
group {commander_mac <macaddr>} – Entering this parameter will display information
concerning the SIM group. To view a specific group, include the commander’s MAC
address of the group.
neighbor – Entering this parameter will display neighboring devices of the Switch. A SIM
neighbor is defined as a switch that is physically connected to the Switch but is not part
of the SIM group. This screen will produce the following results:
Port – Displays the physical port number of the commander switch where the
uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor switch.
Role – Displays the role(CS, CaS, MS) of the neighbor switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To display the SIM information in detail:
