xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
355
48
MAC-BASED ACCESS CONTROL (MAC) COMMANDS
The MAC-based Access Control (MAC) commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
enable mac_based_access_control
disable mac_based_access_control
config mac_based_access_control password
<passwd 16>
config mac_based_access_control method [local | radius]
config mac_based_access_control guest_vlan
ports
<portlist>
config mac_based_access_control ports
[<portlist> |
all] {state [enable | disable] | mode [port_based | host_based] | aging_time [infinite | <min 1–1440>] | block_time
[infinite|<sec 1-300>] | max_users [no_limit |<value 1-4000>]}
(1)
create mac_based_access_control [guest_vlan <vlan_name 32>| guest_vlanid <vlanid 1–4094>]
delete mac_based_access_control [guest_vlan <vlan_name 32>|guest_vlanid <vlanid 1–4094>]
clear mac_based_access_control auth_state [ports [all | portlist] | mac_addr <macaddr>]
create mac_based_access_control_local mac <macaddr> [vlan <vlan_name 32>|vlanid <vlanid 1–4094>]
config mac_based_access_control_local mac <macaddr> [vlan <vlan_name 32>|vlanid <vlanid 1–4094> |
clear_vlan]
delete mac_based_access_control_local [mac <macaddr> | vlan <vlan_name 32>|vlanid <vlanid 1–
4094>]
show mac_based_access_control
{ports {<portlist> }}
show mac_based_access_control_local {[mac<macaddr> | [vlan <vlan_name 32>|vlanid <vlanid 1–
4094>]]}
show mac_based_access_control auth_state
ports <portlist>
config mac_based_access_control
auth_failover
[enable | disable]
config mac_based_access_control
authorization network
{radius [enable | disable] | local [enable | disable]} (1)
config mac_based_access_control max_users [<value 1-4000> | no_limit]
Each command is listed, in detail, in the following sections.
enable mac_based_access_control
Purpose Used to enable MAC-based access control.
Syntax
enable mac_based_access_control
Description This command is used to enable the MAC-based access control function.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
