A SERVICE OF

logo

Open as PDF
next previous
6Ć43 Removal and ReplacementC4699Ć90000
3 Use the right cam journal to lift the
pinchĆwheels, and let the roller drop into
place.
4 Ensure that the bearing assembly at the
right end of the drive roller is seated in
the right sideplate and completely on the
right side of the axial bias plate.
5 Replace the overdrive clips underneath
the media separator.
6 Replace the media mount.
Press down on the media mount as you
replace the three screws. This is to ensure
correct spacing between the drive roller
and the cartridge nozzles.
Press down here as
you tighten screws
MediaĆmotor mount
Torx-20
Calibration: Perform the accuracy
calibration after reassembling the plotter.
(Details ' chapter 7.)