Deleting a Job Storage print job
Sometimes it is necessary to delete a print job from the product hard disk. You can do this from
the product control panel.
1 Press the select button (the one with the check mark) to open the menus. RETRIEVE JOB
is highlighted.
2 Press the select button.
3 Press the up and down buttons to scroll to your User Name, and then press the select
button.
4 Press the up and down buttons to scroll to the Job Name, and then press the select
button.
5 Press the up and down buttons to select Delete.
6 If a PIN number is assigned to the job, press the up and down buttons to select the first
digit of the PIN, and then press the select button. The number in the product control-
panel display changes to an asterisk. Repeat this step for each of the remaining three
digits of the PIN number.
If no PIN number is assigned to the job, continue with step 7.
7 Press the select button to delete the job.
The stored print job is deleted and the product returns to the READY state.
Device Settings tab
The Device Settings tab is in the Properties for the print driver in Windows NT 4.0. In
Windows 98 and Windows Me, a tab with similar options and settings is called the Device
Options tab.
To gain access to the print driver Properties, click Start on the Window task bar, select
Settings, and then click Printers. Right-click the product name, and then click Properties.
The Device Settings tab communicates information about the hardware configuration to the
print driver. The Device Settings tab appears when you open the driver from the Printers
folder by selecting and right-clicking the printer, and then clicking Properties for the driver.
When the driver is opened from within a software program, the Configure tab is not visible.
When opened from the Printers folder, the Device Settings tab appears, as shown in the
following illustration.
Note
EN Chapter 3 HP traditional print drivers for Windows 143
