Virtual Router Redundancy Protocol (VRRP)
Displaying VRRP Configuration and Statistics Data
ProCurve(config)# show vrrp
VRRP Global Statistics Information
VRRP Enabled : Yes
Protocol Version : 2
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
VRRP Virtual Router Statistics Information
Vlan ID : 10
Virtual Router ID : 1
State : Master
Up Time : 31 mins
Virtual MAC Address : 00005e-000101
Master's IP Address : 10.10.10.2
Associated IP Addr Count : 1 Near Failovers : 0
Advertise Pkts Rx : 1213 Become Master : 2
Zero Priority Rx : 0 Zero Priority Tx : 0
Bad Length Pkts : 0 Bad Type Pkts : 0
Mismatched Interval Pkts : 0 Mismatched Addr List Pkts : 0
Mismatched IP TTL Pkts : 0 Mismatched Auth Type Pkts : 0
Figure 6-15. Output for Show VRRP Command Includes Global and VR Statistics
Displaying Statistics for All VRRP Instances in a VLAN
Syntax: show vrrp vlan < vid > [statistics]
This command displays the VRRP statistics for all VRs
configured on the specified VLAN.
The actual statistics data per VR is the same as for the show
vrrp [statistics] command (pages 6-40 and 6-42).
Note that show vrrp vlan < vid > and show vrrp vlan < vid > statistics
produce the same output.
In the following example, there is one VR configured in VLAN 10.
6-42
