24
Mode
Units
Setup Print
Enter
Mode
Units
Setup Print
Enter
4.3 Good Laboratory Practices (GLP) Data
The GLP Data submenu enables the storage of a user identification number (7 digits) and/or a project number
(digits). When entered into the balance, the identification number and project number are available when printing
providing they are turned on in the GLP Set submenu. A lock setting is also available which locks in the user
identification and project number.
Setup
Use keys to change, press Enter
Change
Setup
Use keys to change, press Enter
Change
Procedure
To select any of the items in the GLP Data menu, proceed as
follows:
• Press the Setup button, CAL is displayed.
• Press
or button until GLP DATA is displayed.
• Press Enter button to continue.
• Press
or button until either USER NO,
PROJ NO, LOCK or EXIT is displayed.
• Press Enter button to continue.
• Press or buttons as directed by
the display and enter a 7 digit number for the user ID
number.
• Press Enter button to save setting.
• Press
or button until either USER NO,
PROJ NO, LOCK or EXIT is displayed.
• Press Enter button to continue.
• Press
or buttons as directed by
the display and enter a 7 digit number for the project
number.
• Press Enter button to save setting.
• Press
or button to select next item or EXIT.
• Press Enter button to continue.
Procedure
To select any of the items in the GLP Set menu, proceed as
follows:
• Press the Setup button, CAL is displayed.
• Press or button until GLP SET is displayed.
• Press Enter button to save setting.
• Press or button until either TIME, BAL ID,
USER NO, PROJ NO, DIFF, NAME, LOCK or EXIT is
displayed.
• Press Enter button to save setting.
• Press
or button and select either ON orOFF.
• Press Enter button to save setting.
• Press
or button to continue or EXIT.
• Press Enter button to save setting.
4.4 Good Laboratory Practices (GLP) Set
Good Laboratory Practices (GLP) Set submenu allows the selection and will permit printing of Time, Balance
Identification Number, User Identification Number, Project Number, Difference and Name data to be printed. When
the selected items are set to ON, these items are not displayed. The default setting is OFF. When an external
printer is used, and all items are set ON and the balance is calibrated, the printer will print out calibration data for
audit trail purposes and will indicate date, and time. (It should be noted that the User ID number and Project
number must be entered in the GLP Data submenu before printed data is available).
