37
PP
PP
P Print display data
Field: Weight Mode Stab CR LF
Length: 9 1 5 1 1 1
When "numeric only"data is
selected for output in the
RS232 menu, the Mode field
is not output.
CommandCommand
CommandCommand
Command
CharacterCharacter
CharacterCharacter
Character
DescriptionDescription
DescriptionDescription
Description
CC
CC
C Begin span calibration
xDxD
xDxD
xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
FF
FF
F Print current function.
xx
xx
x
II
II
I Set Averaging Filter Level to “x”,
where x = 0 to 3 (see table).
If LFT, level 0 to 1.
LL
LL
L Begin linearity calibration
xMxM
xMxM
xM Places balance in mode “x”,
where x = 1 to 17 (see table).
If unit or mode is not already
enabled, command will be ignored.
RS232 COMMAND TABLE (Cont.)
0 = minimum level
1=
2=
3 = maximum level
1 = milligrams
2 = grams
3 = kilo grams
4 = dwt
5 = Carats
6 = Ounces
7 = Ounces troy
8 = Grains
9 = Taels Hong Kong
10 = Taels Singapore
11 = Taels Taiwan
12 = Mommes
13 = Decimal Pounds
14 = (Not used)
15 = Newton's
16 = tical
17 = Custom Units
Same as ?
command
Displayed weight sent right justified
w/lead zero blanking.
Nine characters include:
decimal point (1)
weight (7 max)
polarity (1): blank if positive
"-" if negative
xSLxSL
xSLxSL
xSL Set stable data only printing (set x = 0 to 3). If LFT 0 or 1.
TT
TT
T Same effect as pressing O/T button.
VV
VV
V Print EPROM version
Esc VEsc V
Esc VEsc V
Esc V Print balance ID (13 characters).
xZxZ
xZxZ
xZ Set Auto Zero to “x”,where x = 0 to 3 ). 0=Off, 1=0.5d, 2=1d, 3=5d.If LFT,
programs Auto zero level from 0 to 1.
x%x%
x%x%
x% Set % reference function. Uses x (Real Number) as current Percent Reference.
Reference weigh must be entered in grams.
x#x#
x#x#
x# Set PC reference function Uses x (Real Number) as current Percent Reference.
Reference weigh must be entered in grams.
NOTE: Availability of shaded units subject to local regulations.
