A SERVICE OF

logo

Open as PDF
next previous
52
Install the HDD units
Install the HDD units by referring the disk slot number.
Detach the front cover in advance. (+ Page 21)
Install/removeHDDunits
Step 1
Remove the HDD unit brace.
Step 2
Install the HDD units by referring the disk slot number.
(1) Lift the lever on the HDD unit while holding down the
removal knob, and then insert the HDD unit all the way
into the HDD slot.
(2) Pinch the rim on the HDD slot with the hook on the HDD
unit securely.
(3) Press the lever down and push it until the removal knob
clicks.
Important:
• KeeptheremovedHDDunitbracesecurely.Whentrans-
porting the recorder, it is necessary to attach it.
• Harddiskdrivesareprecisedevices.Handlewithcare
while keeping the following in mind.
• Donotsubjecttheharddiskdrivetoanyvibrationor
impact.
Before touching the hard disk drive, eliminate static elec-
tricity by touching a steel locker, etc. When holding the
hard disk drive, hold the both sides of the hard disk
drive.
• Donottouchthecircuitboardortheconnectorstopre-
vent the hard disk drive from damaging by static electric-
ity.
• Contactyourdealerforharddiskdrivesthatworkson
the recorder. Please be forewarned that operation with
any hard disk drive other than the specified models is
not guaranteed under any circumstances.
• Whenusingmultipleharddiskdrives,usethesame
model.
If different models are used together, even when the
capacities of them are the same, the available capacity
may be a few percent smaller.
• Installtheharddiskdrivesonebyoneinorderstarting
from HDD1.(The leftmost slot of the HDD slots is HDD1
and the rightmost one is HDD4.)
• OncetheoperationhasstartedintheRAID5orRAID6
mode, do not change the positions of the HDD units. If
they are changed, it may become impossible to read
recorded data.
HDD unit brace
Removal
knob of the
HDD unit
Lever
(2)
(3)
Removal knob
of the HDD unit
Lever
Rim
Hook