R
Page 16
November 5, 2010
Cumberland Gap Wood Stove
7006-188G
E. Leg Leveling System
Figure 16.3 - Bolt fully extended
Figure 16.2
Figure 16.1
1. Thread Allen bolts through nuts until fl ush. Figure 16.1.
The
Allen bolts and nuts are included in the component pack
inside the appliance fi rebox.
2. Slide assembled nuts and bolts into slots on legs with the
nuts on the bottom. Figure 16.2. Use a 5/32 Allen wrench
to adjust legs up and down to desired level. Figure 16.3.
F. Side Fuel-Loading-Door Locking
Mechanism
The side fuel loading door is shipped locked in place. Figure
16.4
You must fi rst decide where you are locating your stove and
determine if you meet the minimum required clearances
from combustibles for loading wood into the fi rebox from
the side door.
If you do not meet the clearances found on page10, leave the
door locked in place. If you unlock the door without meeting
the minimum required clearances YOU WILL VOID YOUR
WARRANTY AND ASSUME ALL RESPONSIBILITIES.
If you meet the minimum clearances, follow the instructions
to unlock the door.
If in the future you decide to relocate your stove, again
determine if you meet the mimimum required clearances
to combustibles in the new location. If you do not, you are
required to lock the door shut and it must remain locked at
all times.
Instructions To Unlock Side Fuel Door
1. Open front door.
2.. Using a 5-32 Allen wrench, remove the bolt from the
locking bracket. Figure 16.4.
3. Save the bracket and bolt for potential future use.
Figure 16.4
